露天爆破智能设计系统开发及应用

为了提高露天台阶爆破设计的规范化、便捷性，对露天台阶爆破设计系统进行了开发研究。以Visual C++为开发平台，软件采用MFC框架，结合OpenGL三维引擎开发技术，实现软件从底层自主开发生态的建立。通过现场工程实践应用表明爆破设计人员可以轻松通过本系统实现三维环境下的布孔设计和爆破网络设计以及精确的GPS布孔，并取得了良好的爆破效果，提高了台阶爆破的设计质量和设计速度。爆破智能设计系统能够实现矿山爆破设计的数字化、科学化、自动化和高效化，对于露天爆破具有十分重要的意义。     

近50年大黑河流域气候水文要素变化趋势及突变分析

基于大黑河流域6个气象站1966～2013年气温、降水量、蒸发皿蒸发量、相对湿度和日照时数长期数据系列,采用气候倾向率和滑动t检验法分析了近50年大黑河流域气象要素的变化趋势及变异年份。结果表明,大黑河流域整体呈现暖干气候倾向,气温呈显著增高趋势,变化率为0.43～0.57℃/10a,气温增温变点大致出现了两次,分别在1986、1997年;降水量和蒸发量多呈不显著减少趋势,降水量先减(1981年)后增(1990年),蒸发皿蒸发量先减(1986年)后增(1996年);相对湿度、日照时数多呈显著减小趋势。     

VRF制冷系统变吸气状态下频率与阀开度的同步调节

针对变流量制冷(Variable Refrigerant Flow,VRF)系统变吸气状态下带液量的精确控制以及控制元件所引起的滞后或超调现象,以变频滚动转子式制冷系统为研究对象,分别通过恒定频率不同阀开度与恒定阀开度不同频率两个实验,建立其单独控制下的拟合模型,得到其在不同工况下的同步控制方法。结果表明:过热度随阀开度的增大而减小,在过热度为6 K以下,即阀开度为27.8%～30%时,过热度控制难度上升,提高冷冻水温度可改善这一状况;过热度随频率的降低而减小,在过热度为5 K以下,即频率为44.5～46.5 Hz时,控制难度上升;吸气干度随阀开度增大而下降,随频率降低而减小;在某一工况下,以系统质量流量为控制目标,可以拟合得到频率与阀开度的关系式,实现同步控制,在变吸气状态可以精确控制吸气干度,不损坏压缩机,并使系统迅速达到稳定状态。     

综放工作面风量及采空区漏风定量检测

通过对中煤塔山煤矿30509综放工作面采空区漏风及有害气体分析的研究，总结了通过定量连续释放SF₆示踪气体，来检测工作面风量与采空区漏风的方法，测定了沿工作面采空区的漏风分布及漏风流线的深度。采用定时测量法，确定了30509工作面随工作面不断推进，与对应地表发生了导通现象；采用定量测量法，确定了内部漏风量和外部漏风量较大，对综采工作面采空区自然发火存在较大风险，同时提出了防范措施，为减少综放工作面采空区漏风、防止自然发火的发生提供了参考。     

亲子乐园空调送风方式的数值模拟研究

大型综合室内亲子乐园属于高大空间,设有游乐设施和游戏的特殊性使得对空间的舒适性要求一致,但是送风气流遇阻严重,室内存在较多气流死角,影响室内空气质量和儿童健康。因此其空调设计不仅需要考虑温度、风速的空间均匀度,还要考虑各点的空气龄和PMV-PPD指标。以天津某亲子乐园为研究对象,利用scSTREAM软件对适用于该房间的辐射供冷加新风、置换通风、混合通风三种空调方式的送风效果进行数值模拟分析,从流场的均匀性、人员的热舒适性等方面对模拟结果进行探讨,研究结果表明辐射供冷加新风方式的空间均匀性和PMV指标最佳,混合通风方式的空气龄最小。     

Comfort design and optimization of direct expansion multi-connected radiant air conditioning based on 3D flow field simulation

The air conditioning method based on radiation heat exchange has the characteristics of small vertical temperature gradient, high thermal comfort and energy saving, and has become a hot spot of attention. The Fluent numerical simulation, the experiment in this paper studies the direct expansion multi-line radiant air conditioner under the artificially simulated climate environment in winter heating, summer cooling and dehumidification. The temperature difference of the radiation + fresh air mode at the same time indoors under heating conditions is less than 2.5 °C, and the time to reach the indoor set temperature of 24 °C is about 2–3 h. Under cooling conditions, the temperature difference of the radiation + fresh air mode at the same time in the room is about 0.5–2 °C, and the time to reach the indoor set temperature of 26 °C is about 1–3 h. In the fresh air mode, the indoor temperature difference and response time at the same time are slightly larger than the radiation + fresh air mode. The freezing and dehumidification effect of fresh air is obvious, the moisture content of dehumidifying fresh air is between 6.3 and 10.5 g/kg, and the dehumidification efficiency can reach 50%. Under the same artificial simulated climate environment, the consumption of the three modes is not much different. When the outdoor temperature in heating conditions is higher than 9 °C, the fresh air mode can get better, and the radiation + fresh air mode can achieve better comfort when running indoors under various conditions.     

Household biomass fuel use is associated with chronic childhood malnutrition: Result from a nationwide cross-sectional survey in Bangladesh

Despite significant investment, childhood malnutrition continues to be a significant public health problem especially in least developed countries. The aim of this study was to find association between household biomass fuel (BMF) use and childhood malnutrition in Bangladesh using data from Demographic and Health Survey 2011. We included a total 6891 children under 5 years of age in the analysis. The prevalence of wasting, underweight, and stunting from BMF using household was 16.1% (n = 997; 95%CI, 15.1–17.3), 39.0% (n = 2399; 95%CI, 37.1–40.9), and 43.3% (n = 2620; 95%CI, 41.6–45.1), respectively. Underweight and stunting were significantly higher among children from households using BMF compared with the children from CF using households (underweight, biomass vs clean fuel: 39.0% vs. 23.5%, p < 0.001; stunting, biomass vs clean fuel: 43.3 vs. 31.5%, p < 0.001). The use of BMF in the household was significantly associated with underweight (OR = 1.38; 95%CI: 1.10–1.73) and stunting (OR = 1.58; 95%CI: 1.18–1.98) among children <5 years of age after adjusting possible confounders in mixed effect logistic regression analysis. This study found a significant association between chronic childhood malnutrition and household BMF use which is indicating possible alternative risk factor for malnutrition. Further prospective research is required to explore the mechanism of how BMF use results in chronic malnutrition.     

Human responses to high levels of carbon dioxide and air temperature

In this study, 30 subjects were exposed to different combinations of air temperature (T_a: 24, 27, and 30°C) and CO₂ level (8000, 10 000, and 12 000 ppm) in a high-humidity (RH: 85%) underground climate chamber. Subjective assessments, physiological responses, and cognitive performance were investigated. The results showed that as compared with exposure to T_a = 24°C, exposure to 30°C at all CO₂ levels caused subjects to feel uncomfortably warm and experience stronger odor intensity, while increased mental effort and greater intensity of acute health symptoms were reported. However, no significant effects of T_a on task performance or physiological responses were found. This indicated that subjects had to exert more effort to maintain their performance in an uncomfortably warm environment. Increasing CO₂ from 8000 to 12 000 ppm at all T_a caused subjects to report higher rates of headache, fatigue, agitation, and feeling depressed, although the results were statistically significant only at 24 and 27°C. The text typing performance and systolic blood pressure (SBP) decreased significantly at this exposure, whereas diastolic blood pressure (DBP) and thermal discomfort increased significantly. These effects suggest higher arousal/stress. No significant interaction effect of T_a and CO₂ concentration on human responses was identified.     

Real-time molecular characterization of air pollutants in a Hong Kong residence: Implication of indoor source emissions and heterogeneous chemistry

Due to the high health risks associated with indoor air pollutants and long-term exposure, indoor air quality has received increasing attention. In this study, we put emphasis on the molecular composition, source emissions, and chemical aging of air pollutants in a residence with designed activities mimicking ordinary Hong Kong homes. More than 150 air pollutants were detected at molecular level, 87 of which were quantified at a time resolution of not less than 1 hour. The indoor-to-outdoor ratios were higher than 1 for most of the primary air pollutants, due to emissions of indoor activities and indoor backgrounds (especially for aldehydes). In contrast, many secondary air pollutants exhibited higher concentrations in outdoor air. Painting ranked first in aldehyde emissions, which also caused great enhancement of aromatics. Incense burning had the highest emissions of particle-phase organics, with vanillic acid and syringic acid as markers. The other noteworthy fingerprints enabled by online measurements included linoleic acid, cholesterol, and oleic acid for cooking, 2,5-dimethylfuran, stigmasterol, iso-/anteiso-alkanes, and fructose isomers for smoking, C₂₈-C₃₄ even n-alkanes for candle burning, and monoterpenes for the use of air freshener, cleaning agents, and camphor oil. We showed clear evidence of chemical aging of cooking emissions, giving a hint of indoor heterogeneous chemistry. This study highlights the value of organic molecules measured at high time resolutions in enhancing our knowledge on indoor air quality.     

Indoor solid fuel use for heating and cooking with blood pressure and hypertension: A cross-sectional study among middle-aged and older adults in China

A cross-sectional study was conducted to investigate the impact of solid fuel use for heating and cooking on blood pressure (BP) and hypertension, using data from the China Health and Retirement Longitudinal Study (CHARLS). The primary fuels used for indoor heating and cooking were collected by questionnaires, respectively. Hypertension was defined based on self-report of physician's diagnosis, and/or measured BP, and/or anti-hypertensive medication use. Multivariate logistic regression models were constructed to assess the associations. Among 10 450 eligible participants, 68.2% and 57.2% used indoor solid fuel for heating and cooking, respectively. Compared with none/clean fuel users, solid fuel for heating was associated with elevated BP (adjusted β: 2.02, 95% CI: 1.04–3.01 for systolic BP; adjusted β: 1.36, 95% CI: 0.78–1.94 for diastolic BP) and increased risk of hypertension (adjusted odds ratio: 1.15, 95% CI: 1.03–1.29). The impact of indoor solid fuel for heating on BP was more evident in rural and north residents, and hypertensive patients. We did not detect any significant associations between solid fuel use for cooking and BP/hypertension. Indoor solid fuel use is prevalent in China, especially in the rural areas. Its negative impact on BP suggested that modernization of household fuel use may help to reduce the burden of hypertension in China.